News Date:2020-09-18 14:09:58
Chaeng has encountered many customers processing helical ring gears, and most of them only produce a large ring gear accessory. Many customers report that the gears are not as durable as the original gears and their service life is not long. How can we improve the service life of the ring gears?
When a manufacturer produces a helical ring gear, it must first know its angle. As for the angle of the helical ring gear, the result measured by the operator is not very accurate due to the wear of the ring gear. If the gear accessories are processed in this way, it will also cause The spiral angle of the gear is deviated from the original accessories. If the deviated ring gear is installed together, the service life will be greatly reduced.
If the tooth surface contact of the ring gear is large on one side and small on the other, the force will be uneven, and its wear level will be much higher than usual. So how can we ensure the transmission of the ring gear?
When one of the ring gears is damaged, the wear of the other ring gear will be smaller. At this time, it is better to replace this pair of ring gears, so that the helix angles of the gears produced are the same. Because the ring gears are damaged due to uneven contact of the tooth surfaces, always pay attention to the lubrication of the gears, so that the service life of the gears will be prolonged, or in the process of use, if the ring gears have problems, they will immediately stop working and take corresponding measures. If it is impossible to repair, you can replace it.
