News Date:2016-07-21 15:21:53
lime grinding units is a complete line that includes vertical preheater, rotary kiln, grate cooler, air treatment system, raw material conveyor system, finished product conveyor system, raw coal grinding system, and so on. DCS central control system is employed to make concentrated operation management.
1. Raw Material Conveying:
The 20-40mm limestone on the stock ground is sent to storage silo by the B1000 belt conveyor with large inclination. In the storage silo, qualified limestone with granularity more than 10mm will be sent to the gravel silo, while limestone with particle size less than 10mm will be conveyed to the powder silo.
The limestone calcining system is mainly made up of 10.5×8.5m vertical preheater, 4.0×60m rotary kiln and vertical coolder whose output is 600t/d and heat consumption of 5.75GJ/t. Limestone inside the preheater is heated by high-temperature gases from rotary kiln to 600-800°C, at which temperature limestone can be partly decomposed. Then the limestone will be sent by 12 hydraulic push rods to the kiln end, where it will undergo high-temperature calcination before sent to the vertical cooler. The processed limestone will be cooled down by cold air to 65°C. Air from the vertical cooler enters into the rotary kiln as the second air to take part in calcining process.
3. Finished Product Conveying:
The final lime will be sent to the storage bin for final products by NE500 bucket elevator. After screening, qualified lime whose particle size is more than 5mm will be sent to storage for active lime, while powder lime whose size is less than 5mm will be sent to storage bin for powder.
4. Gas Treating:
High-temperature gases from rotary kiln will do heat exchange with limestone inside the preheater, and after that, the temperature of these gases will reduce to lower 280°C. Then these gases will be cooled down by multi-tube cooler to 200°C lower. Finally, they enter into the bag filer before discharged into the atmosphere.
The calcination process adopts pre-heater+ rotary kiln+ vertical cooler system, , it can reduce the fuel consumption 40%, increase output capacity 30% due to reuse the waste gas in the system. The other advantages are in the following.
1.The lime quality is very good and high activity.
2.It is especially suitable for large-scale lime production.
3.The production running is stable, the whole process using negative pressure, air flow freely and high production safety
4.Using the bag filter system, it can reduce the exhaust gas less than 50mg/Nm3
5.It shorten kiln length, reduce heat loss and area.
6.Cooler and kiln hood cover designed together, good seal, saving area.
We can provide technological solutions and complete production equipment for quicklime (active lime) production line.
-Design capacity:50-700TPD
-We have professional engineer team.
-We have mature experience, and project cases more than 100 till 2011.
-We use the new tyoe, energy saving and environmental system, through which fuel consumption can be reduced 40%, output capacity increased 30%.
